X-Cell Furion 450 Assembly Manual
Page 60 of 89
Copyright Miniature Aircraft USA
Created: 8/27/2008
This document may not be distributed without permission of Miniature Aircraft USA
5A.3.a 5A.3.b 5A.3.c 5A.3.d
Building Notes:
Apply a thin coat of green thread
lock on the smaller bearings
using a toothpick. Place a drop
of thread lock on the end of the
toothpick and then smear it
around the bearings. DO NOT
APPLY TO THE BEARING INSIDE
THE GRIP! Wipe away any
excess and be careful not to get
any in the bearing
5A.3.e 5A.3.f 5A.3.g 5A.3.h
5A.3.i 5A.3.j 5A.3.k 5A.3.l
Building Notes:
Insert one of the damper shims
on top of the inside bearing.
OPTIONAL: If you want stiffer
damping for quicker response,
then put a second spacer in each
grip.
Building Notes:
Before installing thrust bearings,
make sure the correct order is
followed. There are two sizes of
the hole in the bearing races.
The race with the larger hole
goes in first. Make sure the
orientation of each bearing part
matches the photos.
5A.3.m 5A.3.n 5A.3.o 5A.3.p
Building Notes:
Install the axle spacer washers
so that the rounded edge faces
outward
#130-060
#130-060
#130-115
#130-112
Spacer goes in recess
#130-062
Insert Bearing
#130-111
Second
#130-111
(optional)
#130-068
Larger hole
#130-068
Bearing
#130-068
Smaller Hole
#130-113
Rounded edge out
