X-Cell Furion 450 Assembly Manual
Created: 8/27/2008
Copyright Miniature Aircraft USA
Page 37 of 89
This document may not be distributed without permission of Miniature Aircraft USA
3A.6.e 3A.6.f 3A.6.g 3A.6.h
Building Notes:
Find a metal tool with a large
flat surface like shown in the
example
Building Notes:
Use the tool to press in the first
bearing. Make sure it is square
on the pitch control ring before
you apply pressure.
Do not drive or hammer the
bearing in, simply apply
pressure to the tool until the
bearing slides in and bottoms in
the ring. Repeat for the second
bearing.
3A.6.i 3A.6.j 3A.6.k 3A.6.l
Building Notes:
Tighten the pitch plate onto the
pitch slider only tight enough to
remove all the slack.
If you over tighten it the
bearings will bind up and be
notchy. If this happens simply
loosen the plate until it turns
smoothly
Be careful not to get thread lock
in the bearings
3A.6.m 3A.6.n 3A.6.o 3A.6.p
Building Notes:
Use a toothpick to apply thread
lock around the edges of the
bearing flanges on both pitch
links and allow it to “wick” in.
Be careful not to get any in the
bearing itself
Wipe off any excess thread lock.
3A.6.q 3A.6.r 3A.6.s 3A.6.t
Building Notes:
Install one of the pitch links onto
the pitch plate as shown.
The bolt goes through the
flanged side of the bearing and
threads into the one of the flat
ends on the pitch plate
Be careful not to get thread lock
into the bearings
Flat Surface
Push down until bearing
seats
#130-058
#130-325
Insert slider through
bearings
#130-320
threads
#130-315
#130-037
Very
carefully
apply
thread lock
around
bearing
flange
edges
with
toothpick
#130-037
flange
