WindGarden
b y p r e m i e r d e s i g n s
Fokker Tri-Plane Airplane Spinner
assembly
instructions
A
B
Step 1
Insert the 2 Landing Gear Struts into the Landing Gear Sleeves. They
should cross each other and form an “X”. (diagram A)
Step 2
Slide the Middle Wing onto the Middle Wing Support Rod located in front
of the pilot. Tighten the “T” Thumb Screw onto the Support Rod. Insert
the Landing Gear Struts into the Diagonal Plastic Fittings on either side of
the wing. Slide the Top Wing onto the tall Top Wing Support Rod located
just in front of the Middle Wing Support Rod. Tighten the “T” Thumb
Screw under the Top Wing onto the Support Rod. Fasten the Wing
Supports attached ot the top of the Middle Wing to the Velcro tabs
underneath either side of the Top Wing. Please note that the black
binding on the wings always faces the rear of the plane. (diagram B)
Plane Fuselage x 1
Wing x 3
Spinner Propeller x 1
Please Note: During
assembly the black edge
always faces the rear of
the plane.
Stabilizer Cross Strut x 1
Landing Gear Struts x 2
Landing Gear Strut
Wing Support
“T” Thumb Screw
Velcro Tab Under Wing
Velcro Tab Under Wing
“T” Thumb Screw
Top Wing
Support Rod
Landing
Gear Struts
Middle Wing
Support Rod
Diagonal Plastic Fitting
Landing Gear Strut
Fuselage
Landing Gear Wing x 1
Machine Guns x 1
Ground Stake x 1
Support Pole x 1
Top Wing
Middle Wing
