28mm Phone Box #2
B28-ST-127
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
The phone part of the box is formed from the three
pieces shown above.
Glue the “handset” into place on the back panel,
then glue the keypad into place as shown.
Remove the base and rear wall from the sprue.
Glue the rear wall to the base, then glue the phone
in front of it. Align the phone using the guide lines
etched into the rear wall.
Glue the two sides into place. Note the one of the right
has notches cut out of it.
Glue the roof into place.
