System Preparation 3-5
No.
Check Item
<6>
The touch screen and the main monitor screens display normally depending on
the system modes and image status.
<7>
The exam date and time are the same as the system date and time, and are
displayed correctly.
WARNING:
If you use a probe giving off excessive heat, it may burn
the patient.
If you find anything not functioning properly, this may
indicate that the system is defective. In this case, shut
down the system immediately and contact Mindray
Customer Service Department or sales representative.
3.3.2
Powering OFF the System
You need to follow the correct procedures to power off the system. In addition, after you
upgrade the software or when the system is down, you need to power off and restart it.
If you will not use the system for a long period of time, you shall:
1. Disconnect the mains power.
2. Turn off powers of all peripherals connected to the system.
To power off your system normally:
Gently press the power button
once on the upper left corner of the control
panel. The Shutdown Confirm screen appears.
z
Shut down: To power off the system normally.
z
Standby: Click to enter the standby status. Press the power button to turn on the
system.
z
Cancel: To cancel the operation.
To shut down the system in a direct way if you cannot do it normally:
Long press the power button and the system will power off without displaying the
[Shutdown Confirm] screen. However, shutting down the system in this way may
destroy the data.
NOTE:
1. DO NOT rush shutdown of the system in a direct way. It may destroy the
data.
2. After the software upgrade, please shut down the system in the normal way
(using “Shut down” method) so as to guarantee a fully update.
3.3.3 Standby
When the battery capacity is charged to the full capacity, the standby time of the system
is no less than 24 hours.
To enter standby:
z
Open [Setup]
→
[System Preset]
→
[General] to set the time for screensaver and
standby mode. If there is no operation, the system enters screensaver after the
waiting time set for screensaver, and if there is still no operation, the system
enters standby after the waiting time for standby.
