Mindray BeneHeart D2, Operator'S Manual

Page: 183 / 208

Defibrillator/Monitor Operator’s Manual E - 1
E
Alarm Messages
This chapter lists only the most important physiological and technical alarm messages. Some messages
appearing on your equipment may not be included.
In this chapter:
■ The “I” column indicates how indications of technological alarms are cleared after the Alarm Pause button
or [ Alarm Reset ] soft key is pressed: “A” means all alarm indications are cleared; “B” indicates alarm
light and alarm tones are cleared and the alarm messages change to prompt messages; and “C” indicates
only alarm tone is disabled, but alarm light and alarm message remain presented.
■ The “L” column indicates the alarm level: “H” refers to high, “M” refers to medium, and “L” refers to low. “*”
means the alarm level is user-adjustable.
■ XX represents a measurement or parameter label, such as ECG, NIBP, HR, PVCs, RR, SpO
2
, PR, etc.
In the “Cause and solution” column, corresponding solutions are given instructing you to troubleshoot
problems. If the problem persists, contact your service personnel.
E.1 Physiological Alarm Messages
Measurement Alarm Message L Cause and solution
XX XX Too High M* XX value has risen above the high alarm limit or fallen below the
low alarm limit. Check the patient’s condition and check if the
patient category and alarm limit settings are correct.
XX Too Low M*
ECG Asystole H Arrhythmia has occurred to the patient. Check the patient’s
condition and the ECG connections.
V-Fib/V-Tach H
Vent. Brady H
Extreme Tachy H
Extreme Brady H
Brady M*
Tachy M*
R ON T M*
PVC M*
VT>2 M*
Couplet M*
Bigeminy M*
Trigeminy M*
Missed Beat M*
Vent Rhythm M*
Multif. PVCs M*
Nonsus. Vtac M*
Pause M*