MIMAKI TEXTILE JET TX1800B, Operation Manual

Page: 72 / 222

2-32
Adjusting the Head Height
Adjust the height of the head in line with the thickness of the fabric you use.
1
Set the fabric.
2
Press the key.
3
Press to select [MAINTENANCE].
4
Press the key.
5
Press to select [Head Height].
6
Press the key twice.
• The carriage will move.
7
Open the front cover and the maintenance cover R.
• Unless the head is properly set at the height against the thickness of the fabric you use, deterioration
of the printing quality or the breakage of the head could be caused. Perform the head height
adjustment each time when you change the fabric.
• When the height of the head is set at 1.3mm (minimum value) from the surface of the platen, pay
attention to the following points:
(1) Use the fabric with surface without wrinkles and convex-concave shapes. The fabric and the
head may graze with each other, or the fabric may be caught and pressed by the head
causing a jam of being clogged at some point.
(2) Use the equipment keeping the head height at 3mm .
• After adjusting the head height, make sure to perform the correction of the dot position. ( P.4-22)
FUNCT I ON
SE TUP
< ENT >
FUNCT I ON
MA I NT ENANCE < ENT >
MA I NT ENANCE
S t a t i o n < ENT >
MA I NT ENANCE
H e a d H e i g h t
< ENT >