MIMAKI TEXTILE JET TX1800B, Operation Manual

Page: 187 / 222

When power of adhesive weakened
5-21
1
2
3
4
5
T
roubleshooting
Peel weakened adhesive
To peel adhesive, the items below are required:
1
Set the doctor on the doctor support as the
figure.
2
Adjust the hexagon nut under the doctor until it comes to the position where the
doctor touches the belt evenly.
3
Fix the round shape nut of the adjustment screw part with your hand to fix the
doctor.
• To peel adhesive coated on before shipment, use the remover attached to this machine. As adhesive
is special one, you cannot peel it with kerosene nor diesel oil.
Notes when removing adhesive
• The worker handling remover shall wear the attached antistatic wrist strap to perform the work.
• Remover, heating oil, gas oil and ethanol are volatile hazardous objects. If you cannot use it all, put a
lid on it and store in a cold dark place for storing hazardous objects.
• When removing adhesive, keep fire away and be sure to turn OFF the belt heater and the main
heater. In addition, be sure to start the work after one hour and more have passed since the heater
was turned OFF.
• Be sure to provide adequate ventilation when removing adhesive.
Item to be used Item to be prepared
Doctor
Gloves
Plastic coma (attached to
this machine)
Remover
Waste cloth
About one liter of kerosene or diesel oil
About one liter of ethanol
Cloth of about 2m x 2m
Resin board of A4 size (thickness of about 1.0 to 3.0mm without sharp edges).
Required not be swollen by ethanol or remover (Ex. material: PVC, PP).
• The doctor is very heavy. When carrying it or
setting it on the doctor support, be sure to
perform the work with two and more persons.
• Be careful not to gap between the doctor and the belt. If there is a gap, remover may leak
from the gap and may stain other parts.
The cog of the
doctor shall be
in the direction
in the photo
seen from the
left side surface.