MIMAKI TEXTILE JET TX1800B, Operation Manual

Page: 152 / 222

4-34
Check ink filling status (filling check)
Print a pattern to check if ink was properly filled with.
1
Make the media feeding system printable.
Switch each item below on the operation touch panel:
• Press [MANUAL] to change it to [AUTOMATIC].
• Press [BELT OFF] to change it to [BELT ON] [FEEDING
ON] and [TAKE-UP ON].
• Press PRESSURE ROLLER [UP] to change it to [DOWN].
• Refer to the assistant function (
P.2-9) to change the
required function to ON.
2
Select [Fill Check] of the maintenance menu.
(1) Press the key.
(2) Press to select [MAINTENANCE] and press the key.
(3) Press to select [Fill Check].
(4) Press the key.
3
Press to select the head to be used
for printing pattern.
Selecting head : Press .
Performing printing : Press .
• If pattern printing is not performed, “-” is displayed on the screen.
4
Press the key.
5
Press to set the origin position.
6
Press the key.
7
Press to enter the print width.
• Make the print width wider as much as possible. If the print width is
narrow, you cannot fully check.
8
Press the key.
• Perform pattern printing.
• When printing is completed, the right screen is displayed.
• If nozzle clogging becomes worse on the way of the pattern,
perform “Normal” or “Hard” ink filling. ( P.4-26, P.4-30)
F i l l C h e c k
C o l o r : 1 2 - - 5 6 7 8
F i l l C h e c k
S e t O r i g i n
: e n t
F i l l C h e c k
P r i n t
: Y = * * * * mm
F i l l C h e c k
P r i n t
: Y = 1 0 0 0mm
* * F i l l C h e c k * *
* *
P r i n t i n g * *
MA I NT ENANCE
F i l l C h e c k < ENT >