MIMAKI JV4 Series, Operation Manual

Page: 140 / 152

- 5.6 -
ERROR MESSAGES
Error messages indicates error numbers.
If any error message is given on the LCD, turn off the power to the device and turn it on after a
while.
If the same error message appears again on the LCD, contact your local MIMAKI distibutor or
MIMAKI office to call for service.
ERROR 01
MAIN ROM
ERROR 02
MAIN RAM
ERROR 03
POWER +5V
ERROR 04
FRASH ROM
ERROR 06
D-RAM
ERROR 07
TEMP (nnnn)
ERROR 08
ENCODER n
ERROR 09
FPGA
ERROR 10
COMMAND
ERROR 11
PARAMETER
Control circuit board is
defective.
Control circuit board is
defective.
POWER+5V
POWER+35V
Control circuit board is
defective.
Abnormal temperature is
detected.
Trouble with detection of linear
encoder.
Control circuit board is defec-
tive.
FPGA Error
HDC Error
The device has received data
other than command data.
A parameter outside the range
of acceptable numeric values
is received.
The interface cable used is not
in conformance with
IEEE1284.
Turn off the power to the device
an turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Securely connect the interface
cable in position.
Turn off the power to the device
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Use an interface cable in
conformance with the standard.
Warning message Cause Corrective measure