- 3.20 -
SETTING THE TYPE OF INK TO BE USED [INKTYPE]
This function selects the type of ink that is to be used.
This device permits up to two types of ink to be loaded. When starting an actual plotting operation,
however, select only one type of ink to be used according to the plotting data and the medium used.
This function can be used when different types of ink are loaded in the device.
As the ink that can be specified, select from the types of ink that have been set in the ink stations.
Pigcm
:
Water-soluble pigment (Light set)
PigOG
:
Water-soluble pigment (Orange, Green set)
Dye
:
Water-soluble dye
Sub
:
Disperse ink (for sublimation transfer)
•
If the same type of ink is set in the ink stations on both sides, the type of ink
cannot be set since [INKTYPE] is not displayed on the LCD.
STEP
1.
Select a type.
(See page 3.4). Here, select [Type.1].
2.
Push the [ENTER] key.
3.
Push the [ ] and [ ] key until the display gives
the indication [INKTYPE].
4.
Push the [ENTER] key.
5.
Set a type of ink to be used by pushing the
JOG keys [ ] and [ ] .
Here, select [Dye].
6.
Push the [ENTER] key.
7.
Push the [END] key twice, and the menu returns
to the LOCAL mode.
SET UP
SELECT
: TYPE.1
TYPE.1
PRINT MODE
< ent >
TYPE.1
INK TYPE
< ent >
TYPE.1
INK TYPE
: Pigcm
TYPE.1
INK TYPE
: Dye
TYPE.1
INK TYPE
< ent >
<< LOCAL >>
width : 1272mm
Summary of Contents for JV4 Series
