MIMAKI JV4 Series, Operation Manual

Page: 65 / 152

- 1.47 -
ESTABLISHING AN ORIGIN
Establish an origin in terms of data on medium loaded on the device. Place the medium on the
device and cause the device to detect the medium, the origin is automatically established at the
location shown in the illustration given below.
Horizontal direction : At a point of 5 mm from the right end.
INITIAL VALUE OF ORIGIN
As the ORIGIN position, the initial value corresponding to the head and operating mode is set. The
origin positions shown below are specified until new origin is set.
Origin position of X-direction (Medium feeding direction)
The following numerical values indicate the distance between the plotting origin and the cutter line.
USE HEAD TEST DRAW REMOTE
ALL 7mm front side 17mm back side
REAR 7mm front side 17mm back
FRONT 7mm front side 7mm back
Origin
5 mm
Roll media