MIMAKI JV4 Series, Operation Manual

Page: 123 / 152

- 4.13 -
WHEN THE MESSAGE [REPLACE WIPER] IS DISPLAYED [WIPER EXCHG]
The wipers are consumable parts. As the wiper continues cleaning the head, it gets stained with ink and
dust. When the message “Replace Wiper” is displayed, replace the wiper with a new one without delay.
At the same time, clean the ink at the bottom of the slider.
•
The wiper is separately available from your local distributor or our office.
• Do not push the [ENTER] key othe than the case of replacing wipers. The
number of wiper operations that is caunted in the Device will be reset. Do
not select [REPLACE WIPER] unless the wiper is to be really changed.
The message [Replace Wiper]
The device counts the number of times the wipers are cleaned and tells when to replace them. When
the message [Replace Wiper] is displayed on the LCD, replace the wipers with new ones.
The message [Replace Wiper] is displayed while the device
is in operation or when the device power is switched on.
There are two different [REPLACE WIPER] messages. If
either of the messages at right appears, replace the wiper
with a new one.
STEP
1. Put the device into the FUNCTION mode.
(See page 4.3)
2. Push the [ENTER] key.
3. Push the [ ] and [ ] key until the display gives
the indication [STATION].
4. Push the [ENTER] key.
5. Push the [ ] and [ ] key until the display gives
the indication [WIPER EXCHG].
6. Push the [ENTER] key.
The carrige will come out of the capping station.
<< LOCAL >>
REPLACE WIPER
FUNCTION
MAINTENANCE
< ENT >
MAINTENANCE
LIST
< ent >
MAINTENANCE
STATION
< ent >
STATION
MENT
: CARRIAGEout
MAINTENANCE
MENT
: WIPER EXCHG
STATION
COMPLATED : ent
<< LOCAL >> RUB
REPLACE WIPER