MIMAKI JV4 Series, Operation Manual

Page: 125 / 152

- 4.15 -
12. Push up the clamp lever.
13. Remove ink at the locations shown at right
using the supplied brush dampened with water.
Clean the locations from the back side of the
device.
• Never rub the nozzle surface because doing so
may cause inferior ink discharge.
15. Close the maintenance cover, then push the
[ENTER] key.
• In the case where a medium is loaded on the
Device, the medium detection display will
appear on the LCD after the initialization.
16. The device enters the LOCAL mode.
ADJUSTING THE HEAD HEIGHT WHEN THE MEDIUM USED IS CHANGED
[HEAD HEIGHT]
See page 1-34, “ADJUSTING THE HEAD HEIGHT WHEN THE MEDIUM USED IS CHANGED”
•
Before adjusting the head height, be sure to remove the medium from the
platen.
If an attempt is made to adjust the head height with the medium kept set on
the platen, the medium gets caught on the carriage during “carriage out”
operation, causing damage to the head.
<< LOCAL >>
INITIALIZING
PLEASE WAIT
Bottom of slider
Nozzle surface