- 3.4 -
REGISTERING TWO OR MORE PLOTTING CONDITIONS AT A TIME
(SELECTING A TYPE)
Register a sequence of plotting conditions set in the FUNCTION mode in the memory of the device.
By allocating the the sequence of plotting conditions to any of Types 1 through 4, it is possible to
reuse the same plotting conditions registered by type. It is, therefore, convenient to allocate different
plotting conditions to different types according to the medium and plotting method used.
The procedure for allocating a specific sequence of plotting conditions to a type is described below.
Here, the method of registration by allocating plotting conditions to a particular type is explained.
STEP
1.
Make sure that the mode is LOCAL mode.
(See to Page 4.3)
2.
Push the [FUNCTION] key.
3.
Push the [ENTER] key.
4.
Select any of Types 1 through 4 by pushing the
JOG keys [ ] and [ ].
There are four types which you can select.
[Type.1]
[Type.2]
[Type.3]
[Type.4]
5.
Push the [ENTER] key.
Setting Plotting Conditions.
(See page 3.5 through 3.28)
Changing the type
If plotting conditions for types 1 through 4 have already been registered, settings can be selected
according to the plotting simply by selecting the type.
1.
Perform steps 1 through 5 above.
Select a type.
2.
Push the [END] key.
Plotting can be started immediately without setting each
plotting condition. (See page 2.6)
<< LOCAL >>
width : 1272mm
FUNCTION
SET UP
< ENT >
SET UP
SELECT
: TYPE.1
SET UP
SELECT
: TYPE.1
TYPE.1
PRINT MODE
< ent >
Summary of Contents for JV4 Series
