MIMAKI JV4 Series, Operation Manual

Page: 141 / 152

- 5.7 -
ERROR 20
I / F BOARD
ERROR 21
I / F NONE
ERROR 23
HOST I / F
ERROR 24
I / F INITIAL
ERROR 30
OPERATION
ERROR 34
DATA REMAIN
ERROR 40
MOTOR X
ERROR 41
MOTOR Y
ERROR 42
X CURRENT
ERROR 43
Y CURRENT
Improper operation has been
conducted on the operation
panel.
No I/F board is attached to the
control board.
HOST I/F Timeout error has
arisen during communication
between the host computer
and interface board.
Initial operation failure of the I/F
board and control board.
An error occurs on the inter-
face between the I/F board and
the control board.
Settings for functions have
been tried to be changed
though there remains received
data that has not yet been
printed.
The Xmotor has been over-
load.
The Ymotor has been over-
load.
Overcurrent error on the
Xmotor has been detected.
Overcurrent error on the
Ymotor has been detected.
Warning message Cause Corrective measure
Turn off the power to the device
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for
service.
Check to be sure that the cable
is securely connected to the host
computer and interface board.
Also, check to ascertain that no
error has arisen on the host
computer side.
Turn off the power to the device
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for
service.
Perform a proper operation.
Print all pieces of received data
or execute the data clear
function. Then, change the
settings.
Turn off the power to the device
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for
service.