MIMAKI JV4 Series, Operation Manual

Page: 74 / 152

- 2.6 -
PLOTTING AN IMAGE FROM SOURCE DATA
STARTING THE PLOTTING OPERATION
This section describes the basic operation of the device.
Plotting conditions can be set on the device side. In this section, however, the method of plotting an
image from data that has been set on the computer side and transmitted to the device is explained.
For the method of setting plotting conditions on the device side, see Chapter 3 "How to Use the
Application Functions."
STEP
1. Turning the power on.
(See page 1.20)
2. Set the medium in position.
(See page 1.37)
3. The device enters the LOCAL mode.
4. Push the [REMOTE] key.
The type of the currently selected plotting condition can be
confirmed. (See page 3.4.)
5. Receive data from the computer.
The plotting conditions that have been set for the data are
displayed.
For the method of data transmission, see the manual for the
output software.
6. During the plotting.
During the plotting operation, the length of the medium
plotted on is displayed.
7. After the plotting operation is completed, push
the [REMOTE] key to put the device back into
the LOCAL mode.
Information on drowing data.
Resolution: 360/540/720/1440 DPI
Length of medium that has been plotted on or the remeining media length
Dividing method : UNI : Unidirectional, B : Bidirectional
Passes : 2pass - 32pass
QUALITY STD
: STANDARD, FINE : HIGHQUALITY, SPD : HIGHSPEED
HOST : When plot setting is made on the computer
<< LOCAL >>
width : 1272mm
< REMOTE >
TYPE. *
0.0m
< REMOTE > 360 x 360
STD / 4P / U / 0.0m
<< LOCAL >>
width : 1272 mm
< REMOTE > 360 x 360
STD / 4P / U / 0.0m