McDATA Enterprise Operating System, User Manual

Page: 46 / 328

2
2-2
Enterprise Operating System Command Line Interface User Manual
Command Overview
Command Overview
Most of the commands in this chapter are listed in alphabetical order
to make them easy to locate. Although the commands can be entered
in any order, depending on the results desired (so long as the tree
structure is followed), the order used herein for the zoning
commands follows a typical order of entry. The various show
commands are usually entered at the end of a group of other
commands to verify configuration changes.
New and Changed Commands
The following CLI commands are new for this edition of the
Enterprise Operating System Command Line Interface User Manual :
• config.fencing.addPolicy on page 2-10
• config.fencing.addPort on page 2-10
• config.fencing.deletePolicy on page 2-11
• config.fencing.removePort on page 2-12
• config.fencing.setParams on page 2-12
• config.fencing.setState on page 2-14
• config.fencing.show on page 2-14
• config.fencing.showTypeTable on page 2-16
• config.ficonCUPZoning.addControlHost on page 2-16
• config.ficonCUPZoning.deleteControlHost on page 2-17
• config.ficonCUPZoning.setState on page 2-17
• config.ficonCUPZoning.show on page 2-18
• config.ficonMS.setMIHPTO on page 2-18
• config.ficonMS.show on page 2-20
• config.ip.lineSpeed on page 2-21
• config.NPIV.maxPortIDs on page 2-22
• config.NPIV.maxPortIDs on page 2-22
• config.NPIV.setState on page 2-23