McDATA Enterprise Operating System, User Manual

Page: 67 / 328

2
CLI Commands
2-23
config
config.NPIV.setState
Syntax
setState NPIVEnabledState
Purpose This command sets enabled state of the NPIV feature. The NPIV
feature key must be installed in order to enable this feature.
Parameters This command has one parameter.
Command Example
Root> config NPIV setState enable
config.NPIV.show
Syntax
show
Purpose This command displays the current NPIV configuration for all ports.
Parameters This command has no parameters.
Command Example
Root> config NPIV show
Output This command displays the following NPIV configuration data:
Output Example The output from the config.NPIV.show command displays as follows:
NPIV state: Enabled
Port Max Allowed NPIV Logins
---------------------------
1
10
2 10
3 10
4 0
5 0
NPIVEnabledState This parameter can be set to enable or disable .
Boolean 1 and 0 values may also be
substituted.
NPIV state The current enabled/disabled state of the NPIV
feature.
Max Allowed NPIV Login Table. A table mapping each port
number on the switch to a corresponding max
number of NPIV logins setting.