McDATA Enterprise Operating System, User Manual

Page: 229 / 328

2
CLI Commands
2-185
show
show.snmp
Syntax
snmp
Purpose This command shows the switch SNMP configuration.
Parameters
This command has no parameters.
NOTE: The command config.snmp.show on page 2-71 has functionality that is
identical to this command.
Command Example
Root> show snmp
Output The switch configuration data is displayed as a table that includes the
following properties.
SNMP Agent
State
The state of the SNMP agent. If it is disabled,
the SNMP state does not respond to any
requests and does not produce any traps.
FA MIB Version
Number
Version of the MIB that the SNMP agent is
configured to use.
Authentication
Traps
The state of the authentication traps (for
example, enabled) that are sent to SNMP
management stations when unauthorized
stations attempt to access SNMP information
from the switch.
Index The community index number.
Community Name The name of the community.
WriteAuth The write authorization state.
Trap Recipient The address of the trap recipient shown in
4-byte dotted-decimal format.
UDP Port
The user datagram protocol (UDP) port number
to which the director or switch will send traps
for each recipient.