McDATA Enterprise Operating System, User Manual

Page: 155 / 328

2
CLI Commands
2-111
perf
the preferred path. All configured paths can be removed by
specifying the
all parameter for both the destination domain ID and
source port.
Parameters This command has the following parameters.
Command Example
Root> perf preferredPath clearPath 10 5
perf.preferredPath.setPath
Syntax
setPath destDomainID sourcePort exitPort
Purpose This command sets a preferred exit port given the destination domain
ID and source port. An exit port can be set for each combination of
destination domain ID and source port.
NOTE: You cannot set a path where the Destination Domain ID is the same as
the Switch's Domain ID.
destDomainId Specifies the destination domain ID. Valid
domain IDs are in the range 1–31 or
all , which
deletes all preferred paths to and from the
source port specified in the sourcePort
parameter.
sourcePort Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
Or you can specify
all to delete all paths to the
destination domain ID.