McDATA Enterprise Operating System, User Manual

Page: 115 / 328

2
CLI Commands
2-71
config
config.snmp.setState
Syntax
setState enabledState
Purpose This command enables or disables the SNMP agent. When disabled,
the SNMP agent does not respond to any requests or send any traps.
Parameters This command has one parameter.
Command Example
Root> config snmp setState 1
config.snmp.show
Syntax
show
Purpose This command shows the switch SNMP configuration.
Parameters This command has no parameters.
Command Example
Root> config snmp show
Output The switch configuration data is displayed as a table that includes the
following properties.
enabledState Sets the state of the SNMP agent. This
parameter can be set to
enable or disable .
Boolean 1 and 0 values may also be
substituted.
SNMP Agent
State The state of the SNMP agent. If it is disabled,
the SNMP state does not respond to any
requests and does not produce any traps.
FA MIB Version
Number Version of the MIB that the SNMP agent is
configured to use.
Authentication
Traps The state of the authentication traps (for
example, enabled) that are sent to SNMP
management stations when unauthorized
stations attempt to access SNMP information
from the switch.
Index The community index number.