McDATA Enterprise Operating System, User Manual

Page: 209 / 328

2
CLI Commands
2-165
show
Parameters This command has the following parameters.
Output The output from show.port.exit includes the following parameters.
destDomainId Specifies the destination domain ID. Valid
domain IDs are in the range 1–31, or, use
all to
show all exit ports to and from the source port
specified in the sourcePort parameter.
sourcePort Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
Or, you can specify
all to show all exit ports to
the destination domain ID specified for the
destDomainId parameter.
Destination
Domain The destination domain ID to which a preferred
path has been configured. This is displayed
only if the destination domain parameter is set
to
all .
Source Port The source port for which a preferred path to
the specified destination domain ID is specified.
This is displayed only if the source port
parameter is set to
all .
Exit Port This is the actual exit port being used for the
given path. The value
No Domain displays when
the destination domain doesn't exist in the
fabric. The value
No Source displays when the
source port is in an offline state. The value
Fabric Building displays when the fabric is still
building.