McDATA Enterprise Operating System, User Manual

Page: 174 / 328

2
2-130
Enterprise Operating System Command Line Interface User Manual
perf
• Ports: None
• Utilization Type: None
• Utilization Percentage: 50%
• Duration: 30 minutes
• Interval: 60 minutes
• Alert State: Disabled
Parameters This command has the following parameter.
TIP:
Although the system supports a name length of 64 characters, you may want to
use a much shorter name. Some commands that display the threshold name show a
maximum of 51 characters. If you specify lengthy names, you can display the complete
name by entering the comma-delimited mode using the commaDelim command. For
more information, see
Using the commaDelim Command on page 1-17.
Command Example
Root> perf thresholdAlerts throughput addAlert port6Rx
perf.thresholdAlerts.throughput.addPort
Syntax
addPort name portNumber
Purpose This command adds a port to the specified throughput threshold
alert.
NOTE:
An alert cannot be modified unless it is in the disabled state. Verify
that the alert is disabled before executing this command.
name Specifies the name of the new throughput
threshold alert. This name can consist of any
ASCII characters up to a maximum length of
64 characters. To use spaces or special
characters in this name, put quotation marks
around the name. This parameter is
case-sensitive.