McDATA Enterprise Operating System, User Manual

Page: 199 / 328

2
CLI Commands
2-155
show
Purpose This command shows the contents of the link incident log on the
director or switch.
ATTENTION!
If the switch is restarted (as occurs during IPL, IML,
configuration reset, feature key installation, or firmware load) or is power
cycled, the information in the link incident log is lost.
Parameters This command has one parameter.
Command Example
Root>
show linkIncidentLog
Output The event log data are displayed as a table that includes the following
properties.
Output Example The output from the show.linkIncidentLog command displays as
follows.
Date / Time Port Link Incident Event
---------------- ---- ------------------------------------------------------
02/27/03 01:28P 20 Not Operational primitive sequence (NOS) received.
02/27/03 01:28P 4 Primitive sequence timeout.
02/27/03 01:27P 62 Not Operational primitive sequence (NOS) received.
02/27/03 01:27P 62 Invalid primitive seq received for current link state
show.loginServer
Syntax
loginServer
Purpose This command displays information from the login server database
for devices attached to this switch. Note that it is possible to have
clear This optional parameter causes all link incident
log entries to be cleared.
Date/Time The date and time when the event occurred.
Port The number of the port where the link incident
occurred.
Link Incident
Event An ASCII string describing the link incident
event.