McDATA Enterprise Operating System, User Manual

Page: 122 / 328

2
2-78
Enterprise Operating System Command Line Interface User Manual
config
Parameter This command has one parameter.
Command Examples
Root> config switch rerouteDelay true
Root> config switch rerouteDelay 1
config.switch.speed
Syntax
speed switchSpeed
Purpose This command sets the speed for the switch.
NOTE: This command is only applicable for the Intrepid 6064.
NOTE: The switch must be set offline before this command is entered.
A switch can be configured to operate at 1 Gbps or 2 Gbps.
If the switch has FPM cards, configuring the switch speed to 2 Gbps
makes all the ports on the FPM cards inactive, and their operational
state will be set to inactive. FPM ports do not support 2 Gbps and,
therefore, will remain inactive after the switch is returned to the
online state.
Parameters This command has one required parameter.
Command Examples
Root> config switch speed 2g
config.switch.show
Syntax
show
rerouteDelayState Specifies whether rerouting delay is enabled.
Valid values are
true and false . Boolean 1 and 0
may be substituted as values.
switchSpeed Specifies the speed of the switch. Valid values
are
1 G/sec or 2 G/sec .