Matrox DigiSuite LE, Installation Manual, Page: 48 / 140

36
Chapter 3, Connecting Your External Devices and Configuring Your BIOS Settings
½
To choose your connection signal options:
1
Set the IN 1 switch to the desired position. If you have an analog
component input source, you must connect it to IN 1, as IN 2 only
supports composite and S-Video inputs.
2
If you have two input sources, set the IN 2 switch.
3
Set the IN MODE switch. The switch position determines which
jacks are available for your input connections (IN 1 and IN 2 on
the breakout box). If you have an analog component input, set the
switch to the COMPONENT ONLY position. Otherwise, set it to
S-VIDEO/COMPOSITE.
Important
If you’re using IN 1 for analog component and IN 2 for
composite, you’ll need to change the IN MODE setting to switch from one
signal to the other.Remember that you’ll also need to change your video
source in the DigiSuite Configuration program as explained in
“Configuring your video settings” on page 61 .
75-ohm termination
The jacks labelled REF on DigiConnect/Video enable you to terminate the
sync signal (with the provided 75-ohm
terminator) or have it loop through.
When using DigiConnect/ Video or another device for termination, make
IN 1
S-VIDEO Y/COMPOSITE R-Y B-Y
Switch position for
analog component
or composite input
Switch position
for S-Video input
COMPOSITE
IN 2
S-VIDEO
Switch position for
composite input
Switch position
for S-Video input
IN MODE
S-VIDEO/COMPOSITE COMPONENT ONLY