Matrox DigiSuite LE, Installation Manual, Page: 102 / 140

90
Chapter 6, DigiSuite LE Troubleshooting
DigiSuite output colors seem incorrect
Possible cause 1 Improper cable connections
Your input/output cables could be
improperly connected. For instance, if you mix up the three analog
component connections, your video monitor will display the wrong color
information.
Possible cause 2 Proc amps not correctly adjusted
These settings are used to adjust
the incoming video signal and may thus need some adjustment.
Solution Check cabling
You need to check your cable connections as
follows:
1
Close all other applications and run the DigiSuite Configuration
program.
2
Click the
DigiSuite LE
tab and then the
Video Out
tab.
3
Load a test pattern such as the 75% color bars. You should verify
the following aspects of your video output:
Try all the different output connections. If there’s a problem on only
one of the outputs, then there could be something wrong with the
cable. If the color is bad on all of the output connections, then there
could be something wrong with your DigiSuite LE card.
Important
Refer to your manual for information on certain
limitations to switch combinations on your video breakout box.
Solution Check live video input
If the video output from DigiSuite is fine,
then you need to troubleshoot your live video input.
1
Set the
Proc Amp
controls in the
DigiSuite LE Video In
dialog
box (of the DigiSuite Configuration program) to default.
2
Make sure that the video source signal type selected in the
DigiSuite LE Video In
dialog box matches that of the actual
physical input connections to DigiSuite LE.
3
Monitor the output of the video source directly to ensure its
integrity before feeding it to DigiSuite LE.
4
If the source output is fine, try all the different input connections,
remembering to change the video input settings in the DigiSuite
Configuration program each time as well.