Matrox DigiSuite LE, Installation Manual, Page: 28 / 140

16
Chapter 2, Installing Your DigiSuite Hardware
Install your DigiSuite LE and optional digital module
Note
Before proceeding, you should review the antistatic and safety
precautions described earlier on page 8 .
1
If slot P1 already contains another PCI card, either move it to an
unused PCI slot or remove it completely.
2
Remove the metal plate located at the back of the PCI slot in which
you’ll be installing DigiSuite LE (generally slot P1). Don't lose the
screw as you'll need it to fasten DigiSuite LE later on.
3
Make sure the termination switch is set to the proper position, as
explained in
“Set the termination switch on DigiSuite LE” on page 14 .
Also, make sure you’ve removed the PCI retainer bracket, as indicated
in
“Removing the PCI retainer bracket” on page 13 , if necessary.
4
Install DigiSuite LE (and optional digital module) in the following
manner:
a
Carefully align the card with its expansion slot.
b
Slide the card towards the slot until it touches. Make sure that the
metal plate at the back of the card slips into the opening left by the
blank metal plate you removed in step
2 . In addition, if you are using
the card retainer bracket, be sure it is aligned with and inserted into
the card guide inside the front of the computer chassis.
c
Once the card touches its slot, make sure it’s perfectly aligned and
then press it into the slot connector until it's firmly in place.
d
Secure the card by fastening its metal bracket to the computer chassis
using the screw you removed in step
2 .
e
If you’ve installed the digital module for DigiSuite LE, connect the
internal cable, as indicated in
“Connect the digital module internal
cable” on page 21 .
5
Once everything is in place, close your computer’s cover.
6
Proceed to “Connecting Your External Devices and Configuring Your
BIOS Settings” on page 23 .