Matrox DigiSuite LE, Installation Manual, Page: 33 / 140

21
Connect the digital module internal cable
7
Continue supporting the Movie-2 bus with one hand while installing
the third card with the other hand.
8
Flip the entire unit over and insert the remaining mounting screws
through the top of the Movie-2 bus. Avoid putting too much stress on
the Movie-2 bus.
9
Carefully install the entire card-bus unit in the intended host computer
making sure all cards are firmly seated in their slots. Secure each
card’s back plate to the computer.
10
If you’ve installed the digital module for DigiSuite LE, you must
connect the internal cable, as indicated in
“Connect the digital module
internal cable” on page 21 .
11
Once everything is in place, close your computer's cover.
12
Proceed to Chapter 3, “Connecting Your External Devices and
Configuring Your BIOS Settings,” on page 23 .
Connect the digital module internal cable
The digital module internal cable is made up of a large cable with video
and audio connectors and a smaller cable with standard internal device
power connectors (similar to the ones you would use to power an internal
CD unit or hard drive).
Important
Remember that the digital module internal cable should
remain connected to the module at all times. Do not try to remove the
internal cable from the digital module or tamper with the audio and video
connectors on the module.