Matrox DigiSuite LE, Installation Manual, Page: 101 / 140

89
Operation
DigiSuite video output is jumpy
Possible cause Improper genlocking
Your genlock termination and/or cable
connections may not be set up properly.
Solution Check genlock
Check various aspects of your genlock setup as
follows:
1
If you’re using an external sync signal, make sure the cable is
properly connected and terminated only once.
2
Select the
External VTR Quality
setting in the
General
dialog box
of the DigiSuite Configuration program only if you’re genlocking
to your source VTR.
3
Finally, try the Internal genlock setting in the General dialog box.
If the video output from DigiSuite is fine, then you know there is
probably something wrong with the external genlock setup.
4
Try clearing the Source has built-in TBC option in the DigiSuite
LE Video In dialog box of the DigiSuite Configuration program.
5
Monitor the live video directly from the VTR to determine its
stability before using it as a DigiSuite genlock source.
6
If the source video is fine, but the video output from DigiSuite is
still jumpy, check your genlock setup.