Matrox DigiSuite LE, Installation Manual, Page: 26 / 140

14
Chapter 2, Installing Your DigiSuite Hardware
Set the termination switch on DigiSuite LE
Important
Make sure you’ve read the “Antistatic and safety
precautions” on page 8 before handling your DigiSuite LE card.
DigiSuite LE provides a DIP switch for 75 ohm blackburst termination for
the REF IN connection. This is located at the top of the module board near
the connection end of the card.
Normally, you should set both switches to the position marked “ON”
before installing DigiSuite LE in your system. If you’re using the
DigiConnect/Video breakout box or another device for termination,
however, set both termination switches to Hi Z.
Assemble DigiSuite LE and the optional digital module
Important
Make sure you’ve read the “Antistatic and safety
precautions” on page 8 before handling your digital module.
If you’re upgrading to the DigiSuite LE digital module (that is, if you
already have DigiSuite LE installed in your system and wish to add the
digital module), refer to the Digital Module Upgrade for DigiSuite LE
Quick Installation for complete installation procedures. This sheet is
supplied with the digital module.
1
Lay DigiSuite LE on a flat surface so that the module board is facing
up.
Switch position
for Hi Z
(required for use with
DigiConnect/Video)
Switches 1 and 2 in “ON” position for
75 termination
Ω
O N O N
1
2
Boogie
Oogie
Oogie!
Boogie
Oogie
Oogie!