215333
172
Revision A
1004027
A
B
C
Figure 4.82: Disc Blade Aligned with Hole in
Rock Guard
4.
Rotate disc (A) so blade (B) faces forward and lines up with
hole (C) in rock guard.
1004028
B
C
A
Figure 4.83: Disc Blade
5.
Place a pin (or equivalent) in the front hole of the rock
guard to prevent disc rotation while loosening blade bolts.
6.
Clean debris from blade attachment area.
7.
Remove nut (A) and discard.
IMPORTANT:
Nuts are one-time-use only. When flipping or changing a
blade, replace using a
NEW
nut only.
8.
Remove shoulder bolt (B) and blade (C).
Installing Disc Blades
CAUTION
Disc blades have two sharp cutting edges that can cause serious injury. Exercise caution and wear gloves when working
with blades.
IMPORTANT:
If you are unsure which direction the spindles rotate, refer to
4.4.6 Reconfiguring Cutterbar Crop Stream, page 164
.
