215333
240
Revision A
1019417
A
B
C
Figure 4.241: R113 PT Clutch Driveline
8.
For R113 PT clutch driveline:
a.
Assemble forward half (A) of clutch driveline onto
female half and attach to shaft on hitch driveline (B).
b.
Position U-joint (C) as shown.
1019431
A
B
C
D
Figure 4.242: R116 PT Clutch Driveline
9.
For R116 PT clutch driveline:
a.
Assemble forward half (A) of clutch driveline onto
female half and attach to shaft on hitch driveline (B).
b.
Position the U-joint (C) and grease fitting (D) as shown.
NOTE:
Before installing the driveline, refer to
to ensure proper orientation.
1019429
A
Figure 4.243: R113 PT Clutch Driveline
10. Move the shield cone to expose the U-joint.
NOTE:
Shield cone not shown in illustration at right.
11. Clean the taper pin threads.
12. Install taper pin so groove on pin is aligned with groove on
shaft. Ensure there is no grease on taper pin threads after
installing into yoke.
13. Torque taper pin nut (A) to 150 Nm (110 lbf·ft). Pin should
be recessed 9
–
11 mm (3/8
–
7/16 in.) into yoke.
IMPORTANT:
Check taper pin torque every 25 hours until it stops moving,
then check before every season.
