215333
158
Revision A
Removing Cutterbar Spindles
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove key, and
engage lift cylinder lock-out valves before going under machine for any reason.
CAUTION
Disc blades have two sharp cutting edges that can cause serious injury. Exercise caution and wear gloves when working
with blades.
1.
Park on a flat, level surface.
2.
Lower the rotary disc pull-type fully.
NOTE:
To prevent oil from spilling from the cutterbar when removing disc spindles, ensure the rotary disc pull-type is on a
flat, level surface and is tilted all the way back.
3.
Shut down the engine, and remove the key from the ignition.
1003631
Figure 4.55: Cutterbar Doors
–
R1 Series Rotary Disc
Pull-Type
4.
Open cutterbar doors. For instructions, refer to
.
1011304
A
A
B
Figure 4.56: Cutterbar Disc Bolts
5.
Place a pin (or equivalent) in the front hole of rock
guard (B) to prevent disc rotation while loosening bolts.
6.
Remove four M12 bolts (A) and washers.
