215333
293
Revision A
1022673
A
B
C
D
E
Figure 4.363: Conditioner Drive
NOTE:
Ensure proper pulley configuration installation
—
the large
pulley is installed onto the gearbox for both roll and finger
conditioners.
21. Install conditioner drive belts (A) onto the pulleys.
22. Check that the tensioner spring is installed at the correct
location:
•
Hole (D) for a roll conditioner
•
Hole (E) for a finger conditioner
23. Tighten idler tensioner nut (C) until spring length (B)
measures 366 mm (14 3/8 in.).
24. Tighten the jam nut.
25. Replace the driveshields. For instructions, refer to
Installing Driveshields, page 221
1014366
A
B
C
D
E
Figure 4.364: Electrical Harness
26. If a transport system is installed, reconnect electrical
harness (A) to lights (B), and secure the harness to the
shielding using existing clamps (C) and (D).
NOTE:
R113 PT:
Harness for rotary disc pull-type is secured with
one plastic clamp (D).
NOTE:
R116 PT:
Harness for rotary disc pull-type is secured with
two plastic clamps.
27. Secure the harness to the light bracket with cable ties (E).
1015093
A
Figure 4.365: Electrical Harness
28. Tighten four M10 hex head bolts (A) and flat washers.
Torque to 29 Nm (21 lbf·ft).
29. Check the float settings. Refer to
for float adjustment instructions.
