215333
205
Revision A
1024792
A
Figure 4.160: Drum Disc
3.
Position the drum disc assembly as shown.
NOTE:
Orient the disc so that the blades are at 90° (1/4 turn) to
the adjacent disc.
4.
Use a 305 mm (12 in.) extension and 16 mm deep socket to
install four M12 bolts (A) and washers that hold the drum
disc in place. Torque hardware to 85 Nm (63 lbf·ft).
1011147
A
B
C
D
Figure 4.161: Driveline
5.
Lubricate spindle splines (A). For specifications, refer to the
inside back cover of this manual.
NOTE:
The driveline U-joints were greased at the factory and are
considered to be lubricated for life. No further lubrication is
required.
NOTE:
For clarity, the illustration shows a cutaway view of the
drum and the tube shield.
6.
Insert driveline (B) at an angle and guide it past hub
drive (C) and drum (D).
7.
Insert splined spindle end (A) into the splined bore on
driveline (B).
1011137
A
A
B
C
Figure 4.162: Driveline
8.
Place a bead of medium-strength threadlocker
(Loctite
®
243 or equivalent) around the threads of four
M12 hex flange head bolts (A). Use the bolts and spacers to
secure driveline assembly (B) to hub drive (C). Torque bolts
to 102 Nm (75 lbf·ft).
