215333
290
Revision A
1022671
B
A
C
Figure 4.354: Drive Pulley
4.
Tighten the three M10 bolts while maintaining 11 mm
(7/16 in.) dimension (B) between pulley (A) and
gearbox (C). Torque the bolts to 39 Nm (29 lbf·ft).
1022670
A
B
C
Figure 4.355: Tensioner
5.
Position tensioner assembly (A) as shown, and secure with
M16 x 120 bolt (B) and nut (C). Torque nut (C) to 51 Nm
(38 lbf·ft).
1022672
A
B
C
D
E
F
G
Figure 4.356: Tensioner
6.
Install spring (A) into rear hole (B) for a finger conditioner,
or forward hole (C) for a roll conditioner.
7.
Install eyebolt (D) onto tensioner (E) and spring (A). Secure
the eyebolt with hardened washer (F) and two M10
nuts (G).
NOTE:
Install the conditioner drive belt after reattaching the
header to the carrier.
