215333
276
Revision A
4.7.3
Servicing Red Brake/Tail Lights
Replacing Red Brake/Tail Light Bulb
1010534
A
Figure 4.316: Plastic Lens and Screws
1.
Remove two Phillips screws (A) from fixture, and remove
the plastic lens.
2.
Replace bulb, and reinstall plastic lens and screws.
NOTE:
Bulb
—
Trade #1157.
Replacing Red Brake/Tail Light Fixture
1010535
B
A
Figure 4.317: Red Hazard Light and Mounting Bracket
1.
Cut cable ties (A) securing harness covering to light.
2.
Retrieve connections from inside harness covering
(approximately 150 mm [6 in.] from light) and disconnect
wires (not shown). If necessary, remove tape.
3.
Remove four nuts (B) securing light to bracket, and remove
light. Pull wires through hole in bracket.
4.
Feed connectors of new light (not shown) through hole in
bracket, and position light onto bracket.
5.
Install four nuts (B) and tighten.
6.
Connect wires to connectors in harness, and secure harness
covering with tape and cable ties (A) as required.
