215333
281
Revision A
Separating Header from Carrier
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
The rotary disc pull-type includes a header and conditioner attached to a carrier frame. Before removing or installing the
conditioner, the header and carrier must be separated.
1004134
Figure 4.328: Rotary Disc Pull-Type Centered behind
Tractor
1.
Connect the rotary disc pull-type to the tractor. For
instructions, refer to
3.7 Attaching Rotary Disc Pull-Type to
2.
Start the tractor and center the rotary disc pull-type behind
tractor.
3.
Raise the rotary disc pull-type fully, set center-link to mid-
position, and shut off the engine. Remove key from
ignition.
NOTE:
The float adjuster bolt is easier to turn when the rotary disc
pull-type is in the raised position.
1030463
B
C
D
A
Figure 4.329: Right Float Adjuster
4.
Close the lift cylinder lock-out valves (A). Repeat on
opposite side.
5.
Loosen retaining bolt (B) and rotate cover plate (C) away
from float spring bolt (D). Repeat on opposite side.
