LumaSense SmartDGA, Hardware Manual

Page: 54 / 114

SmartDGA Hardware Manual SmartDGA System Installation
•
54
2. Line up the provided EZHub panel mount brackets (PN Left - 115-0087-01 and
Right – 115-0097-01) with the holes on the back of the EZHub.
3. Fasten with the 8 screws/washer/split-washer provided.
Note: The screw heads on the yellow band will cause some spacing between the brackets
and the EZHub enclosure. Use your judgement to align the brackets properly.
4. Determine location for the 4 panel holes and drill.
5. Install customer-provided fasteners (#10 or M5 screws) to secure the SmartDGA EZHub to
the front panel.
5.2.3 Connecting the EZHub
Communications Cable
The SmartDGA ® system requires a power/communications
cable with multi-pin connector to be connected from the
SmartDGA device to the SmartDGA EZHub
TM
controller.
The standard connection cable length is 10 meters and
longer cables (up to 30 meters (98 ft)) are also available.
The standard connection cable is outdoor weather rated
for -20 °C to 150 °C. If extreme weather conditions exist,
an extended weather rated cable is available (rated for -50 °C to 125 °C.)
11.58”
(294.13 mm)
5.00”
(127 mm)
12.33”
(313.18 mm)