LumaSense SmartDGA, Hardware Manual

Page: 73 / 114

SmartDGA Hardware Manual SmartDGA Commissioning
•
73
If successful, you will see a screen similar to the following:
4. If needed, edit any of the device settings. Click
Save Settings
. Any changes you made will
then be saved to the EZHub. If you change the IP Address, you then need to reboot the
EZHub. Make sure the lights are off before supplying power back to the EZHub.
Note:
If installing multiple EZHub controllers, the
EZHub ID
should be changed to the
next value (i.e. start at 48, then use 49, 50, 51, …).
The
Transformer ID
or
LTC ID
should be unique for each unit connected.
5. The software will then search for SmartDGA instruments located connected to the EZHub
and save the information to the instrument(s). If one is not found, or you are still unable to
connect to the instrument, please check your connections and try again.
6. After you save your settings, click Next > to continue. The information will be loaded onto
the EZHub(s) and SmartDGA instrument(s).
Note:
The information is not carried over into the DGA Viewer software. Make note of
the IP Address and ID.