Lucent Technologies SLC-2000 Access System Central Office Terminal, Assembly Manual

Page: 104 / 284

3-38 Issue 5 May 1997
363-208-010
Cabling, Wiring, and Assembly
Connecting Procedures for Transmission
Cable Assembly ED7C723-34 Group 6
This procedure consists of installing the FITL HDOS to MDS Interconnect cables
and mating their connectors to their respective shelf dangler cables.
Refer to Figure 3-21 and note that up to two HDOS shelves may be provided and
up to eight cable assemblies connected for a complete RT Bay FITL application.
Note that the HDOS OU circuit pack positions have a similar numbering scheme
as the MDS CU slots. This association can be used in troubleshooting and
isolating problems relating to cable assignments. Refer to Table 3-2 for HDOS and
MDS slot association.
NOTE
:
There is no associated cable connection to the MDS connectors P104 or
P204.
Connections
Step 1:
Install the interconnecting cable assemblies in the appropriate duct and
mate their connectors in accordance with the assigned MDS and HDOS
positions.
NOTE
:
The factory assembled cable connectors are universally
stamped P191/P192, J101/J201, J102/J202, J103/J203. For
ease of installation erase or cover that part of the label that is
not relevant before mating to its associated connector. For
example some relevant labeling would be:
a. P191-1, J101, J102, J103
b. P192-1, J201, J202, J203
Step 2: Tie the cables in the duct space wherever appropriate.