Lucent Technologies SLC-2000 Access System Central Office Terminal, Assembly Manual

Page: 173 / 284

363-208-010
Cabling, Wiring, and Assembly
Issue 5 May 1997
3-107
Ringing Cable ED7C723-34 Group 16
This cable provides the +20Hz/-20Hz ringing connections to the Auxiliary Fuse
Panel.
Step 1: Connect the leads in accordance with the associated figure for the J116
connector at the assigned fuse positions for the INTS.
Step 2: Mate the J116 connector with P116 on the INTS.
Step 3: Assign the INTS fuse positions with a 1/2 amp fuse each for the positive
and negative ringers.
INTS Control Link Cable
This cable is the control link with the INTS. Refer to Figure 5-7 in Chapter 5 for its
wiring details.
Step 1: Locate the INTS's six foot dangler cable (RS232/P44) and route it into
the front right cable duct.
Step 2: Mate the INTS cable's P44 connector to the J44 connector of the ARM
shelf dangler cable ED7C723-30 Group 17 installed earlier.
INTS Communications Cable
This cable is the CIT link with the INTS. Refer to Figure 5-6 in Chapter 5 for its
wiring details.
Step 1: Locate the INTS's six foot dangler cable (CIT/P183) and route it into the
front right cable duct.
Step 2: Mate the INTS cable's P183 connector to the J183 connector of the
ARM shelf dangler cable ED7C723-30 Group 18 installed earlier.
DC Test Pairs Cable ED7C723-35 Group 1, 2, or 3
This cable assembly, containing the test access pairs, is connected to the Misc.
Pairs Cross-connect block.
Step 1: Mate the cable's J305 connector with the INTS's P305 connector.
Step 2: Terminate and label the leads in accordance with the associated figure
for J305 in this section.
VF Pairs Cable ED7C723-35 Group 1, 2, or 3
This cable assembly, containing VF test pairs is connected to the Misc. Pairs
Cross-connect block.
Step 1: Mate the cable's J801 connector with the INTS's P801 connector.
Step 2: Terminate and label the leads in accordance with the associated figure
for J801 in this section.