Lucent Technologies SLC-2000 Access System Central Office Terminal, Assembly Manual

Page: 164 / 284

3-98 Issue 5 May 1997
363-208-010
Cabling, Wiring, and Assembly
VF Pairs Cables ED7C723-35 Group 1, 2, or 3
Step 1: Add the additional VF interconnect cable (ED7C723-35 G1, 2, or 3) and
connect its connector to the Multiple cable's P101B connector.
Step 2: Re-stamp the original ED7C723-35 VF cable's J101 connector as J101A
and stamp the additional cable's connector as J101B.
Step 3: Connect the additional cable at the Misc. Pairs Cross-connect and des-
ignate the leads in accordance with Figure 3-32 associated with the
J101B connector.
Test Bus (TAP) Multiple Cable ED7C723-34 Group 14
This multiple cable is used only in applications with multiple RT systems utilizing
the LTF.
Step 1: Mate the cable's J301 connector with the bay's TAP Bus P301 connec-
tor. Replace the DC test Pair Cable ED7C723-35 Group 7 (refer to
above paragraph) if it is in place.
Step 2: Position the cable so that its J301B connector is accessible at the top of
the bay and its P101A connector is accessible for connections to the DC
Test Pair cables.
DC Test Pair Cable ED7C723-35 Group 1, 2, or 3
This cable assembly, containing all test access pairs from the RT bay TAP bus, is
utilized with the Reliance INTS system and connected to the Misc. Pairs Cross-
connect block.
Step 1:
Mate the cable's connector with the bay's TAP Bus P301 connector or
TAP Bus P301A connector. Replace the DC Test Pair Cable ED7C723-
35 Group 7 (refer to above paragraph) if it is in place.
Step 2:
Stamp the connector as J301, terminate and label the leads in accor-
dance with the associated figure in this section.