Lucent Technologies SLC-2000 Access System Central Office Terminal, Assembly Manual

Page: 29 / 284

363-208-010
General Information
Issue 5 May 1997
1-5
General Safety Admonishments
Important General Safety Instructions
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Do not place the shelves on an unstable cart, stand, or table. The product
may fall causing serious damage to the equipment.
4. Slots and openings in these shelves are provided for ventilation. To protect
it from overheating, these openings must not be blocked or covered. This
equipment should not be placed in a built-in installation unless proper ven-
tilation is provided.
5. Never push objects of any kind into this product through cabinet slots as
they may touch dangerous voltage points or short out parts that could
result in a risk of fire or electrical shock. Never spill liquid of any kind on the
product.
6. For information on proper mounting instructions consult the appropriate
section in this installation manual.
Electrical Wiring Admonishments
Important Installation Safety Instructions
1. Read and understand all instructions and warning labels.
2. Installation and maintenance procedures must be followed and performed
by trained personnel only. Do not allow non-service personnel to access
electrical wiring.
3. All VF, DS1, STS-1E, and DS3 interfaces should not leave the building pre-
mises unless connected to telecommunication devices providing primary or
secondary protection, as applicable.
4. Never install telecommunication wiring during a lightning storm.
5. Never install telecommunication connections in wet locations.
6. Never touch uninsulated telecommunication wires or terminals unless the
telecommunication line has been disconnected at the VF, DS1, STS-1E, or
DS3 interface.