
Malfunction, cause and remedy
17
Disturbances at the pick-up or during picking up of crops
17.1
Comprima V 180
Original Operating Instructions 150001053_00_en
195
17
Malfunction, cause and remedy
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
To avoid accidents, the relevant safety instructions must be read and observed,
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
The safety routines must be read and observed to avoid accidents,
.
17.1
Disturbances at the pick-up or during picking up of crops
Disturbance:
The pick-up cannot be lowered.
Possible cause
Remedy
The hydraulic hose has not
been inserted in the tractor.
Correctly connect the hydraulic hose for the pick-up,
Disturbance:
There are crop blockages in the intake area.
CAUTION! Machine damage due to crop blockages! Immediately stop, switch off PTO
shaft and remove the crop blockages.
Possible cause
Remedy
The swaths are uneven or too
large.
Divide the swaths.
The tractor driver is driving too
fast.
Reduce the driving speed.
Slow down at the beginning of the baling process until the
picked up crops roll into the bale chamber.
The machine height has not
been set correctly with respect
to the tractor.
Set the machine correctly using the drawbar from the
KRONE service partner,
.
The crop press roller unit has
been set too low.
Set the crop press roller unit higher,
.
Disturbance:
Short crops are not pulled in correctly.
Possible cause
Remedy
The machine is hooked in too
low in the front.
Check the setting of the drawbar.
If necessary, have a KRONE service partner adjust the
drawbar height,
Malfunction:
Crops are conveyed upwards from the bale formation conveyor.