Krone Comprima V 180, Original Operating Instructions, Page: 150 / 242

15 Settings
15.5 Setting wrapping material brake
150
Comprima V 180
Original Operating Instructions 150001053_00_en
The more the spring (3) is tensioned, the greater the brake force release during the feed
process.
ü The actuator for wrapping process is in the feed position, refer to page 125 .
ü
The machine is shut down and safeguarded, refer to page 25 .
„ Check that the disc (2) is located above the spring (3) at the level of the central notch (4).
„
To change the tension of the spring (3), loosen or tighten the nut (1).
Notches (4) Spring tension (3) Wrapping material for the feed pro-
cess
top low The wrapping material can be pulled
with difficulty.
central medium The wrapping material can be pulled
with medium strength. KRONE re-
commends this setting as an op-
timum brake force release during the
feeding of the wrapping material.
bottom strong The wrapping material can be pulled
easily.
15.5 Setting wrapping material brake
For version with "Net wrapping"
RP000-020
The wrapping material brake is located on the right side of the machine under the storage
compartment.
The spring (2) is mounted in such a way that the brake pad (1) is pressed onto the brake disc
(not shown in the picture). This ensures that the wrapping material brake decelerates the
feeding of the wrapping material to the round bale. If the net was wrapped around the round
bale too loosely or too tightly, the brake force can be set with the nut (4) on the eyelet bolt (3).
Default dimension set by KRONE: X=40 mm
ü
The machine is shut down and safeguarded, refer to page 25 .
ü The roll holder has been swivelled forwards.
„
To increase the brake force, increase the dimension X.
„ To reduce the brake force, reduce the dimension X.