Krone Comprima V 180, Original Operating Instructions, Page: 147 / 242

Settings 15
Setting the bale diameter 15.2
Comprima V 180
Original Operating Instructions 150001053_00_en 147
Due to the hydraulical design of the accumulator connection block, the baling pressure may
drop over a prolonged period of time.
„
In order to obtain the baling pressure last set, open and close the tailgate once using the
control unit (red, 1+).
15.2 Setting the bale diameter
15.3 Setting the density of the bale core
The bale core density can be adapted to differently structured crops in the following 2 ways:
• Adjusting the bale formation conveyor tension
• Setting the double rocker arm
Then check again whether the spring of the bale formation conveyor tension has been correctly
set.
The bale core density can be adjusted to differently structured crops by setting the double
rocker arm. Then check again whether the spring of the bale formation conveyor tension has
been correctly set.
Adjusting the bale formation conveyor tension
2
1
3
1
4
RP000-491
ü
The machine is shut down and safeguarded, refer to page 25 .
ü The left side hood is open.
„
To achieve a softer bale inner core, unhook the rope (1) of the hydraulic tensioning device
on the spring hook (2) from the holder (3) and hook into the holder (4).
Setting the double rocker arm
2
1
3
RPG000-095