Krone Comprima V 180, Original Operating Instructions, Page: 161 / 242

Maintenance 16
Maintenance table 16.1
Comprima V 180
Original Operating Instructions 150001053_00_en 161
16.1.2 Maintenance – once after 10 hours
Components
Retighten wheel nuts refer to page 172
Tighten the screw connections on the drawbar refer to page 177
Check tyre pressure refer to page 172
Have the slack adjuster of the brake system
checked by KRONE service partners
Check the hydraulic hoses for leaks and, if ne-
cessary, have them replaced by a KRONE
service partner.
Clean the bushing and the drawbar eye refer to page 176
Check rear bale formation conveyor and ad-
just if required refer to page 185
16.1.3 Maintenance – once after 50 hours
Changing oil
Main gearbox refer to page 173
16.1.4 Maintenance – Once after 500 round bales
Components
16.1.5 Maintenance – every 10 hours, at least daily
Checking oil level
Main gearbox refer to page 173
Components
Clean the machine refer to page 174
Check that the brake system functions
Clean the bushing and the drawbar eye refer to page 176
Check dosing units of the central chain lubric-
ation system and clean if required refer to page 189
16.1.6 Maintenance – every 50 hours
Components
Tighten screws/nuts on the machine refer to page 166
Tighten the screw connections on the drawbar refer to page 177
Retighten wheel nuts refer to page 172
Check tyre pressure refer to page 172
Drain condensation water out of the com-
pressed air tank refer to page 191